Omron V440-F, User Manual

Page: 335 / 500

Appendices
G-30 V440-F C-Mount Code Reader User Manual
G-19 DotCode
Important:
When
DotCode
is enabled, no other symbologies will be decodable. You must disable
DotCode to decode symbols of any other type.
The reader will not attempt to decode DotCode symbols.
The reader will attempt to decode DotCode symbols.
The reader will decode horizontal and vertical symbols (
+/–
approximately
3 degrees
).
The reader will decode
+/–
approximately
10 degrees
from the horizontal or vertical symbols. It is
slightly slower than the No Rotation option.
The reader will support
360 degree
reading. Omnidirectional is significantly slower than the other two options.
G-19-1 DotCode Status
Serial Cmd:
<
K497, status ,rotation mode,expected rows,expected columns
>
Default: 0 = Disabled
Options: 0 = Disabled
1 = Enabled
Disabled
Enabled
G-19-2 Rotation Mode
Serial Cmd:
<
K497, status, rotation mode ,expected rows,expected columns
>
Default: 0 = No Rotation
Options: 0 = No Rotation
1 = Low Rotation
2 = Omnidirectional
No Rotation
Low Rotation
OmniDirectional
G-19-3 Expected Rows
Definition: Expected Rows
allows you to specify the exact number of rows in the code to minimize
the possibility of decoding errors and no reads. If you specify the exact row dimensions,
only DotCode symbols of the same dimensions are decoded.
Serial Cmd:
<
K497, status,rotation mode, expected rows ,expected columns
>
Default: 0
Options:
0 to 256
G-19-4 Expected Columns
Definition: Expected Columns
allows you to specify the exact number of columns in the code to
minimize the possibility of decoding errors and no reads. If you specify the exact column
dimensions, only DotCode symbols of the same dimensions are decoded.
Serial Cmd:
<
K497, status,rotation mode,expected rows, expected columns
>
Default: 0
Options:
0 to 256