Nivus NivuFlow Mobile 600, Instruction Manual, Page: 28 / 125

Instruction manual
NivuFlow Mobile 600
page 28 rev. 00 / 04.09.2017
Installation and Connection
14 General
14.1 Installation Place
For safe installation at the chosen place the measures below must be taken:
 Ü
Protect the transmitter from direct sunlight. Install a protective cover if necessary.
 Ü
Observe the permitted ambient temperature.
 Ü
Do not expose the transmitter to heavy vibration or mechanical shocks.
Selecting the installation place strictly avoid:
• Corrosive chemicals or gases
• Radioactive radiation
• Installation close to footpaths or travel ways
14.2 Before Installation
CAUTION Suspend the instrument only by using appropriate safety belts
The instrument shall be suspended into shafts or manholes only by using the carrying
handle and appropriate belts, ropes or similar.
It is not allowed to suspend the device by the sensor cable since this may lead to cable
break, leaky plug connection or the transmitter may be torn off.
14.2.1 PU stickers on enclosure frame
 Ü
Prior to first use of the NivuFlow Mobile 600 make sure that the PU stickers have been
removed. If not, remove the stickers and clean the enclosure frame if necessary.
F c
See chapter „11.3 Reception inspection“.
14.2.2 Gaskets
 Ü
Check the gaskets on the enclosure cover.
Before closing the cover make sure that the gasket is clean and undamaged, so:
• remove debris and/or dirt
• replace defective gaskets
• apply silicone grease if necessary
Gaskets
The manufacturer cannot be held responsible for any instrument damage resulting from the
use of defective or leaking gaskets.