Parameter Setting
page 101
rev. 00 / 04.09.2017
30.6 Storage Mode
The >Storage Mode< menu determines the >Operating Mode< and the >Storage Cycle<.
Fig. 30-8
Storage Mode – Operating Mode
Operating Mode, Storage Cycle and Event Interval
The operation mode determines when and how often the transmitter shall measure and when
and how often the measurements shall be saved. Storage cycle and event interval can be
adjusted depending on the operation mode.
To choose the
>Operation Mode<
select from
•
>Cycle Mode<
The transmitter wakes up at the intervals set in storage cycle, executes a brief meas-
urement and saves the data. After that the transmitter goes back to "sleep mode" until
the next measurement.
•
>Event Mode<
On one hand, the transmitter behaves like being in cyclic operation, however it is pos-
sible to additionally set an event interval. The transmitter then wakes up at previously
defined events, measures and saves data at the adjusted event intervals.
•
>Continuous Event Mode<
In this mode the transmitter basically operates like being event operation, however
measures continuously during the event. The instrument saves the data at the
adjusted event intervals.
•
>Continuous Operation<
The transmitter measures continuously, however will save the data only at the inter-
vals set with the storage cycle.
>Event<
Currently the function "Digital Input on" is invariably saved as event.
This setting may be extended in later firmware versions possibly presenting a selection menu.