82
OPERATING PROCEDURES
:
Drilling Settings
{
Hole angle
Set the angle with the hole angle button.
Pressing the button changes the settings in the following order.
• Auto
• Angle
• X-Y
• X Auto
• Curve
Only Auto, Angle, or Curve is selectable when the paired, notched or counterbored holes are
selected.
Change the value with the ten-key pad displayed by pressing the numeric field.
Auto
Make a hole vertically against the lens front side of the hole position.
Angle
Specify the tilt of the axis direction.
With 0°, it becomes parallel to the chuck shaft.
Entering a positive value tilts in the direction of
the clamp axis.
X-Y
Specify the X axis (horizontal) direction and Y axis (vertical) direction tilt.
In the Y axis (vertical) direction, with 0°,
it becomes parallel to the clamp shaft.
Entering a positive value tilts the hole
upward and downward in the direction
of the clamp axis.
In the X axis (vertical) direction, with 0°,
it becomes parallel to the clamp shaft.
Entering a positive value tilts the hole
right and left in the direction of the
clamp axis.
X Auto
Specify the tilt of the Y axis (vertical) direction.
In the X axis (horizontal) direction, the hole is tilted by 90° with respect to the lens
front.
In the Y axis (vertical) direction, with 0‹, it becomes parallel to the clamp shaft.
Entering a positive value tilts the hole upward and downward in the direction of the
clamp axis.
Curve
Make a hole vertically against the entered curve value.
Chuck shaft
χ
;
ω
;
χ
;
ω
;
:
φψ
:
:
φψ
:
