Murphy EMS-GC10, Operator'S Manual

Page: 173 / 183

Section 75 00-02-0878
2013-03-07 - 167 -
NOTE: If a relay output is chosen, the relay in question must be set
up to be a limit relay output. This is done in the parameter list
under "OUTPUTS".
NOTE: If a relay output is chosen, the relay in question must be set
up to be an alarm/limit output (input/output settings, icon in the top
of the USW).
Definitions
The TRUE and FALSE states are explained below.
A TRUE state of an input/event will be detected, if the condition defined in the
input/event is met.
Examples given:
Digital input is TRUE when activated (12/24V DC applied).
Alarm condition is TRUE when the alarm is present.
Mode condition is TRUE when the mode is selected.
A FALSE state of an input event will be detected, if the condition defined in the input
event is not met.
Examples given:
Digital input is FALSE when deactivated (12/24V DC not applied).
Alarm condition is FALSE when the alarm is not present.
Mode condition is FALSE when the mode is not selected.