Murphy EMS-GC10, Operator'S Manual

Page: 180 / 183

Section 75 00-02-0878
2013-03-07 - 174 -
Output Description Notes
Set parameter 2
Set parameter 3
Set parameter 4
Select test type to simple Test sequence selection.
Select test type to full
Block GB sequence Block the operation of the genset breaker.
Select application 1 Power management: Four different applications can
be stored at the same time in the units. Here the
selection between them can be made.
Select application 2
Select application 3
Select application 4
Run my ID Runs the connected mains
Run one mains Run one mains only
Run all mains Run all mains in application
Update mode local Running mode update.
Update mode on all Running mode update
Store common settings Broadcast the common settings to all units.
Open GB Generator breaker.
Close GB
Open MB Mains breaker.
Close MB
Start and close GB Start the engine and close the breaker/open the
breaker and stop engine.
GB open and stop
Auto start/stop ON = Start, OFF = Stop.
Remote start Pulse signal.
Remote stop Pulse signal.
Deactivate base load Disables the base load function.
First priority Forces this unit to have the first priority in a power
management system.
Select 3-phase system Selects to measure AC voltage on a 3-phase system.
Select split L1 L3 phase system Selects to measure AC voltage on a 2-phase system.
Select split L1 L2-phase system Selects to measure AC voltage on a 2-phase system.
Select single phase system Selects to measure AC voltage on a 1-phase system.
Idle run low speed Idle speed constant low speed.
Idle run temp control Idle speed temperature-dependent.
Cool down threshold Interrupt cool down sequence.
Activate all AOP-2 buzzers All AOP-2 buzzers.
Activate all AOP-2 relays All AOP-2 relays.
Activate relay on
AOP-2 ID1 Single AOP-2 relays.
Activate relay on
AOP-2 ID2
Activate relay on
AOP-2 ID3
Activate relay on
AOP-2 ID4