Murphy EMS-GC10, Operator'S Manual

Page: 8 / 183

Section 75 00-02-0878
2013-03-07 - 2 -
Warnings and Legal Information
Legal Information and Responsibility
FW Murphy takes no responsibility for installation or operation of the generator set. If there is
any doubt about how to install or operate the engine/generator controlled by the EMS-GC10
unit, the company responsible for the installation or the operation of the set must be
contacted.
IMPORTANT: The EMS-GC10 unit is not to be opened by
unauthorized personnel. If this occurs, the warranty will be void.
Disclaimer
FW Murphy reserves the right to change any of the contents of this document without prior
notice.
Electrostatic Discharge Awareness
Sufficient care must be taken to protect the terminals against static discharges during the
installation. Once the unit is installed and connected, these precautions are no longer
necessary.
Safety Issues
Installing and operating the EMS-GC10 unit may imply work with dangerous currents and
voltages. Therefore, the installation should only be carried out by authorized personnel
who understand the risks involved in working with live electrical equipment.
WARNING: Be aware of the hazardous live currents and voltages.
Do not touch any AC measurement inputs as this could lead to
injury or death.
Factory Settings
The EMS-GC10 unit is delivered from the factory with certain factory settings. These are based
on average values and are not necessarily the correct settings for matching the
engine/generator set in question. Precautions must be taken to check the settings before
running the engine/generator set.
NOTE: When the controller unit operates for the first time after it has been
received from the factory, both mains and generator breakers alarms will
be activated to warn the user (shown as fault), until they are connected to
the power system and reset accordingly.