Murphy EMS-GC10, Operator'S Manual

Page: 90 / 183

Section 75 00-02-0878
2013-03-07 - 84 -
34. MB spring loaded
EMS-GC10 genset controller unit will not send a close signal before this feedback is
present.
35. D+ (digital running feedback)
This input is used as a running indication of the engine. When the input is activated, the
start relay is deactivated. This is the input for running feedback from charge generator
+D terminal. (Runs when charger (voltage) U > battery voltage).
36. Inhibit EI alarms
When this input is active, it will inhibit all engine interface [(Engine Interface
Communication, (EIC) (J1939)] alarms.
NOTE: The input functions are set up with the PC utility software
(USW), please refer to "Help" in the USW for this.
Outputs
The unit has a number of output functions which can be configured to any available
relay.
Output Function Auto Semi Test Man Block Configurable Output Type
1 Status OK X X X X X Configurable Constant
2 Run coil X X X X X Configurable Constant
3 Stop coil X X X X X Configurable Constant
4 Prepare X X X X X Configurable Constant
5 Starter (Crank) X X X X X Configurable Constant
6 Horn X X X X X Configurable Constant
7 GB on X X X X X Configurable Continuous
8 GB off X X X X X Configurable Continuous
9 MB on X X X X X Configurable Continuous
10 MB off X X X X X Configurable Continuous