Murphy EMS-GC10, Operator'S Manual

Page: 182 / 183

Section 75 00-02-0878
2013-03-07 - 176 -
Output Description Notes
CAN
Command
CAN command 01-16 active
Alarm Ind.
Leds
LED X Red + blink
X = ID number (01-04).
LED X Red
LED X Yellow
+blink
LED X Yellow
LED X Green + blink
LED X Green
Activate view 1-20 on display 1 Activate a specific view on display 1.
Quick SetUp
Off
Quick setup for application configuration. Setup stand alone
Setup plant
EIC
Command
EIC droop Activate ECU droop.
EIC droop emulation
Activate droop in the ML-2 (reference setpoint still
nominal frequency/power but regulation loop is with
added droop for stability).
EIC reset trip fuel Reset fuel counter in the ECU.
EIC enable cylinder cutout Allows cylinder cutout.
EIC engine over-speed test Initiate over-speed test.
EIC intermittent oil priming Activate oil priming pump.
EIC Engine opr mode command Set the operating mode of the engine.
EIC Engine speed gov param command Select default or variant 1 governor parameter setting.
EIC DPF regeneration inhibit
The Regeneration Disabled (Inhibit) switch disallows
any automatic or manual (non-mission) regeneration
of the diesel particulate filter.
This may be used by the operator to prevent
regeneration when the machine is operating in a
hazardous environment and the OEM is concerned
about high temperature.
EIC DPF regeneration force
The Regeneration Initiate switch initiates a manual
(non-mission) regeneration of the particulate filter
when the machine is in non-mission condition and
DPF soot levels are high enough to allow
regeneration.
This switch is for use in forcing a regeneration event
to occur to troubleshoot the system. During a non-
mission regeneration the engine speed will increase
to an optimum speed for regeneration.
Inh EIC alarms
Inhibit of EIC alarms; red/yellow/
protection/malfunction.
EIC Select Cummins PCC1301
Enable speed control for PCC
1301.
EIC Start/stop enable Switch ON/OFF the start and stop commands.
EIC Speed control inhibit Disable the EIC speed control.