Mitel 3300, Technician'S Handbook

Page: 313 / 431

303
Typical Network Configurations
Layer 2 Switch Settings (Example)
Table 61 and Table 62 show examples of settings on a Cisco and an HP
Layer 2 switch for this example. See Figure 120 for the port numbers.
Tip: These settings also apply for the other network configuration examples.
Table 61: Cisco Layer 2 Switch Settings Example -
Configurations 1, 2 and 3
Port Use Command
A Access port
for VLAN 1 None (by default, all ports belong to VLAN 1)
B
C Access port
for VLAN 2 Router(config-if)#switchport mode access
Router(config-if)#switchport access VLAN 2
D
E Trunk port
with Dot1q for
IP Phone Router(config)#interface fast 0/5
Router(config-if)#switchport mode trunk
Router(config-if)#switchport trunk encapsulation dot1q
Table 62: HP Layer 2 Switch Settings Example -
Configurations 1, 2 and 3
Port Use Command (on HP VLAN menu)
A Access port for VLAN 1 VLAN 1 = untagged
VLAN 2 = NO
B
C Access port for VLAN 2 VLAN 1 = NO
VLAN 2 = untagged
D
E Trunk port VLAN 1 = untagged
VLAN 2 = tagged
Note: For additional switch setting examples, refer to to the Network
Configuration Specifics chapter in the 3300 ICP Engineering Guidelines .