Mitel 3300, Technician'S Handbook

Page: 87 / 431

77
Installation and Programming
1. On the Maintenance PC, access the System Administration Tool (see
"Log into the Programming Tools" on page 71).
2. Select View Alphabetically in the view drop-down list.
3. Click DHCP Subnet form, enter the subnet name, IP address and bit
mask.
4. In the DHCP Static IP form, enter a static IP address for the E2T using
the information in Table 50 on page 276. Assign IP addresses to
specific devices by using the MAC address of the device. Assign a
static IP Address to any IP Console in a cluster.
5. In the DHCP IP Address Range form, program the scope using the
information in Table 51 on page 277. Also see Table 48, “Reserved IP
Addresses,” on page 271.
6. In the DHCP Options form, program the options listed in Table 52 on
page 278 for the scope you just programmed. Always create the
following options:
- 3 Router, IP address
- 125 Vendor-Identifying Vendor-Specific Information or Option 43
Vendor Specific Information. Option 125 is the preferred option
- 66 TFTP Server, IP address format
- 67 Boot file, string value (always /sysro/E2T8260)
If there are 5230 IP Appliances, create the following options:
- 6 DNS Server, IP address format
- 44 NetBIOS Name Server, IP address format
7. In the DHCP Lease Viewer form, ensure that there is no DHCP IP
Address Lease for the IP Console MAC Addresses. If there is, delete
it and then power off and power on the device.
8. In the DHCP Server form, enable the internal DHCP server.