Mitel 3300, Technician'S Handbook

Page: 74 / 431

64
3300 ICP Technician’s Handbook
7. Power up the SX-200 Bay. Once the CIM or FIM link synchronizes, the
CIM or FIM LEDs turn on. The controller detects the Bay and
downloads firmware to it. After the download, the Bay is automatically
started.
8. Using the System Administration Tool, program the SX-200 Bay
settings on the controller. Refer to the System Administration Tool
Help for instructions.
Install Telephones
This section contains information on installing telephone sets, consoles,
and other peripherals.
The 3300 ICP supports a number of IP, DNI, analog and wireless phones,
as well as conference units, programmable key modules, and attendant
consoles. The CX/CXi and CX II/CXi II controllers only support IP and
analog phones.
If you have a peripheral cabinet with analog/DNIC phones connected to it,
program those telephones using the System Administration Tool.
Install Telephones, Consoles and Appliances
Refer to each device’s Installation Guide (included in the telephone
package) to install the devices.
Tip: You cannot use the Group Administration Tool to modify programming
for SUPERSET 400-series telephones.
Note: Each IP Phone must be directly connected to an L2 switch port. DO
NOT connect them in series (daisy-chaining) using the 2nd LAN port in
the phone. If daisy chained, a problem with one phone can affect all the
others in the chain. Also, all chained phones share the same bandwidth.
Note: If you intend to rely on LLDP VLAN Discovery in the network, you must
first upgrade the 3300 ICP to Release 7.0 or later and upgrade the IP Phone
firmware to version 2.0.0.18 or later.
Note: LLDP-MED non-compliant telephones cannot use LLDP for VLAN
discovery. They must use DHCP VLAN discovery. Non-compliant sets are:
5001, 5005, 5010, 5020 IP Phones, 5140 IP Appliance, 5201, 5205, 5207,
5215 (single mode), 5220 (single mode), 5230 IP Phones, 5240 IP Appliance,
5485 IP Pager, and 5550 IP Console keypad.