Mindray uMEC10, Operator'S Manual

Page: 84 / 288

7-12
7.5.3 Setting Alarm Delay Time
You can set the alarm delay time for over-limit alarms of continuously measured parameters.
If the alarm-triggered condition disappears within the delay time, the patient monitor will
not give the alarm. You can set the [ Alarm Delay ] in the [ Others ] window of [ Alarm
Setup ] menu.
To set the alarm delay time,
1. Select [ Main Menu ] [ Maintenance >> ] [ User Maintenance >> ]. Enter the
required password and then select [
Ok
].
2. Select [ Alarm Setup >> ][ Alarm Delay ].
Alarm delay is not applied to the following physiological alarms:
„
Apnea
„
ST alarms
„
Arrhythmia alarms
„
ECG Weak Signal
„
Resp Artifact
„
No Pulse
„
Measurements of noncontinuous parameters over alarm limits
„
HR over alarm limits
You can set [ Apnea Delay ] and [ ST Alarm Delay ] separately.
7.5.4 Setting SpO
2
Technical Alarm Delay
You can set [ Tech. Alarm Delay ] in the [ Others ] tab of the [ Alarm Setup ] menu. The
options are [
Off
], [
5s
], [
10s
] and [
15s
]. The delay is effective to the following technical
alarms: SpO
2
Sensor Off, SpO
2
Too Much Light, SpO
2
Low Signal and SpO
2
Interference.