Mindray uMEC10, Operator'S Manual

Page: 47 / 288

3-11
When a parameter is switched off, its corresponding parameter module stops working, and its
parameter value and waveform are not shown on the monitor display.
NOTE
z
ECG is always selected, and you cannot switch it off.
3.10.2 Accessing the Parameters Menu
Select [ Parameters >> ] from the main menu or select corresponding parameter area or
waveform area to access a parameter setup menu.
3.11 Operating Modes
Your monitor has different operating modes. Some are password protected. This section lists
the major operating modes.
3.11.1 Monitoring Mode
This is the normal, everyday working mode that you use for monitoring patients. Your
monitor automatically enters the monitoring mode after being turned on.
3.11.2 Night Mode
To avoid disturbing the patient, night mode may be used.
To activate the night mode:
1. Select [ Main Menu ][ Screen Setup >> ][ Night Mode >> ].
2. In the pop-up menu, set the desired brightness, alarm volume, QRS volume, key volume,
NIBP end tone, or whether to stop NIBP measurement or not. When [ Stop NIBP ] is
selected, all the NIBP measurements terminate after entering the night mode.
3. Select the [ Enter Night Mode ] button.
To cancel the night mode:
1. Select [ Main Menu ][ Screen Setup >> ][ Night Mode >> ].
2. Select [
Ok
] in the popup.