Mindray uMEC10, Operator'S Manual

Page: 183 / 288

20-3
When a recording is stopped, the following markers will be added:
„
Automatically stopped recording: print two columns of ‘*’ at the end of the report.
„
Manually or abnormally stopped recording: print one column of ‘*’ at the end of the
report.
20.4 Setting Up the Recorder
20.4.1 Accessing the Record Setup Menu
By selecting [ Main Menu ][ Record Setup >> ], you can access the [ Record Setup ] menu.
20.4.2 Selecting Waveforms for Recording
The recorder can record up to 3 waveforms at a time. You can select, in turn, [
Waveform 1
],
[ Waveform 2 ] and [ Waveform 3 ] in the [ Record Setup ] menu, and then select the
waveforms you want. You can also turn off a waveform recording by selecting [
Off
]. These
settings are intended for realtime and scheduled recordings.
20.4.3 Setting the Realtime Recording Length
After starting a realtime recording, the recording time depends on your monitor’s settings. In
the [ Record Setup ] menu, select [ Length ] and toggle between [ 8 s ] and [ Continuous ].
„
[ 8 s ]: record 4-second waveforms respectively before and after current moment.
„
[
Continuous
]: record the waveforms from the current moment until stopped manually.
20.4.4 Setting the Interval between Timed Recordings
Timed recordings start automatically at preset intervals. Each recording lasts 8 seconds. To
set the interval between timed recordings: in the [
Record Setup
] menu, select [
Interval
] and
then select the appropriate setting.
20.4.5 Changing the Recording Speed
In the [
Record Setup
] menu, select [
Paper Speed
] and toggle among [
12.5 mm/s
], [
25
mm/s ] and [ 50 mm/s ]. This setting is for all recordings containing waveforms.