Mindray uMEC10, Operator'S Manual

Page: 162 / 288

16-6
16.6 Changing CO
2
Settings
16.6.1 Changing CO
2
Alarm Settings
1. Select the CO
2
parameter area or waveform area to enter the [ CO2 Setup ] menu.
2. Select the [ Alarm Setup ] tab.
3. Set the following alarm properties:
‹
Switch on or switch off the alarms or alarm recording.
‹
Adjust the alarm limits or alarm priority.
‹
Select [
Apnea Delay
] to set the delay time of the apnea alarm.
16.6.2 Changing the CO
2
Unit
1. Select [ Main Menu ][ Maintenance >> ][ User Maintenance >> ] enter the
required password and then select [ Ok ].
2. Select the [ Unit Setup ] tab.
3. Set [ CO 2 Unit ].
16.6.3 Setting the CO
2
Waveform
In the [ CO2 Setup ] menu, you can:
„
Select [ Wave Type ] and toggle between [ Draw ] and [ Fill ]:
‹
[
Draw
]: The CO
2
wave is displayed as a curved line.
‹
[ Fill ]: The CO
2
wave is displayed as a filled area.
„
Select [
Sweep
] and then select the appropriate setting. The faster the wave sweeps, the
wider the wave is.
„
Change the size of the CO
2
waveform by adjusting the wave [ Scale ].
16.6.4 Setting the RR Source
1. Select the CO
2
parameter area or waveform area to enter the [ CO2 Setup ] menu.
2. Set [ RR Source ].
When the current RR source does not have valid measurement, the system will automatically
switch [ RR Source ] to [ Auto ].
The [ RR Source ] settings of Resp and CO
2
module are linked. For details, please refer to 9.9
Setting RR Source
.