Mindray Accutorr 7, Operator'S Manual

Page: 44 / 200

3 - 8 Accutorr 7 Operator’s Manual
◆
[ No ]: the patient’s name does not display in the main screen.
3.6.5 Adjusting Alarm Volume
1. Select [ Main ]
→
[ General Setup>> ].
2. Select [ Alarm Volume ] and then select the appropriate volume. The alarm volume
range is between X to 10. X is the minimum volume, which depends on the setting
of minimum alarm volume (refer to
6.5.2 Setting the Minimum Alarm Volume ), and
10 the maximum volume.
The alarm tone is switched off when the volume is set to [
0
].
WARNING
•
Do not rely exclusively on the audible alarm system for patient monitoring.
Adjustment of alarm volume to a low level may result in a hazard to the
patient. Always keep the patient under close surveillance.
3.6.6 Adjusting Key Volume
1. Select [ Main ]
→
[ General Setup>> ].
2. Select [ Key Volume ] and then select the appropriate volume: 0-10, in which 0
means off, and 10 the maximum volume.
The monitor can provide a tone according to the settings in key volume when you press
the knob or hard key, or touch the screen.
3.6.7 Adjusting the Screen Brightness
1. Select [ Main ]
→
[ General Setup>> ].
2. Select [ Brightness ] and select the appropriate setting for the screen brightness.
10 is the brightest, and 1 is the dimmest.
If the monitor operates on battery power, you can set a dimmer screen to prolong the
battery operating time. When the monitor enters Standby mode, the screen
automatically changes to the dimmest setting.
3.6.8 Setting Screen
You can set the main screen to one of the three pre-defined layouts as desired.
To set the screen:
1. Select [ Main ]
→
[ General Setup>> ].
2. Select [ Display Setup ] and set the main screen to different layout: All Parameters
display, Trend display or NIBP List display.
◆
All Parameters display includes parameter area, waveform area, but no
trend.