Mindray Accutorr 7, Operator'S Manual

Page: 127 / 200

Accutorr 7 Operator’s Manual 14 - 7
4. Select [ Ok ] to exit the menu.
14.2.7 Setting the Data Encryption Switch
The data encryption switch is off by default. To turn on the data encryption switch,
follow this procedure:
1. Select [ Main ]
→
[ Maintenance >> ]
→
[ User Settings >> ]
→
Enter the required
password
→
Select [ Ok ].
2. Select [
Network>>
].
3. Set [ Data Encrypt Switch ] to [ On ].
NOTE
•
Before switching on the data encryption switch, ensure that the eGateway
version you are using is version 6.4.0 or greater
.
Older version of the
eGateway may fail to handle the patient information.
14.3 Connecting the monitor to the CMS
To connect the monitor to the CMS, proceed as follows:
1. Select [ Main ]
→
[ Maintenance >> ]
→
[ User Settings >> ]
→
enter the required
password
→
Select [ Ok ]
→
[ Network >> ]
→
[ Monitor Network Setup >> ].
2. Set [ Network Type ] and [ Address Type ].
3. Input the monitor IP address, subnet mask and gateway address if the [ Address
Type ] is set to [ Manual ].
4. Connect the monitor to the CMS through either of the following methods:
◆
Admit the monitor on the CMS. Refer to the Hypervisor VI Operator’s Manual
(PN: 300B-20-47610) for details of admitting a monitor.
◆
Setting the CMS (refer to 14.3.1 Setting the CMS for details), and then
selecting a CMS (refer to 14.3.2 Selecting a CMS for details).
14.3.1 Setting the CMS
You can configure up to 30 central stations (CMS) for your monitor. To set the CMSs ,
1. Select [ Main ]
→
[ Maintenance>> ]
→
[ User Settings >> ]
→
enter the required
password
→
Select [ Ok ]
→
[ Network >> ]
.
2. Set [ Select CMS ] to [ On ].
3. Select [ Central Station Setup >> ].
4. Set CMS names and corresponding IP addresses.