Starting up the device - IO-Link interface
Leuze electronic GmbH + Co. KG
CML 730i
80
Open the configuration software of the IO-Link master module.
Configure the following parameters:
- Beam mode (parallel-, diagonal-, crossed-beam)
- Blanking settings
- Teach settings
Perform a teach. This is possible via the receiver control panel or the control group in the IO-Link pro
-
cess data (IO-Link object 2).
If necessary, configure additional parameter/process data (see chapter 10.3).
Save the configuration via the control group in the IO-Link process data (IO-Link object 2).
The IO-Link-specific configurations are performed and copied to the device. The device is prepared for
process mode.
10.3 Parameter/process data for IO-Link
The parameter data and process data are described in the IO-Link Device Description (IODD) file.
Details on the parameters and on the structure of the process data can be found in the .html document,
which is contained in the IODD zip file, and on the Internet at www.leuze.com.
Overview
The IO Device Description (IODD) can be used both with connected light curtain for direct con
-
figuration or without connected light curtain for creating device configurations.
The IODD files are supplied with the product. The IODD can also be downloaded from the Inter
-
net at www.leuze.com.
Sub-index access is not supported.
Group
Group name
Group 1
System commands (see page 81)
Group 2
CML 700i status information (see page 81)
Group 3
Device description (see page 82)
Group 4
General configurations (see page 83)
Group 5
Extended settings (see page 84)
Group 6
Process data settings (see page 84)
Group 7
Cascading/trigger settings (see page 85)
Group 8
Blanking settings (see page 86)
Group 9
Group 10
Digital IO pin N settings (N = 2, 5, 6, 7) (see page 88)
Group 11
Time module settings for digital outputs (see page 89)
Group 12
Analog device settings (see page 90)
