Lenovo ThinkServer RS110, Hardware Maintenance Manual

Page: 24 / 252

CD drive activity LED: When this LED is lit, it indicates that the CD drive is in use.
Rear view
The following illustration shows the LEDs on the rear of the server.
1
Ethernet 1 activity LED
3
Ethernet 2 activity LED
2
Ethernet 1 link LED
4
Ethernet 2 link LED
Ethernet activity LED: This LED is on each Ethernet connector. When this LED is
lit, it indicates that there is activity between the server and the network.
Ethernet link LED: This LED is on each Ethernet connector. When this LED is lit, it
indicates that the Ethernet controller is connected to the network.
The following illustration shows the connectors on the rear of the server.
1
Power-cord connector
5
Ethernet 1 connector
2
Systems-management connector
6
Ethernet 2 connector
3
USB 3 connector
7
Video connector
4
USB 4 connector
8
Serial connector
Power-cord connector: Connect the power cord to this connector.
Serial connector: Connect a 9-pin serial device to this connector.
Video connector: Connect a monitor to this connector.
Ethernet connector: Use either of these connectors to connect the server to a
network. Ethernet connector 1 supports Serial over LAN (SOL).
USB connector: Connect a USB device to either of these connectors.
Systems-management connector: Connect the server to a network for
systems-management information control. This connector is active only if you have
installed a Remote Supervisor Adapter II SlimLine, and it is used only by the
Remote Supervisor Adapter II SlimLine.
6
ThinkServer RS110 Types 6435, 6436, 6437 and 6438: Hardware Maintenance Manual