Lenovo ThinkServer RS110, Hardware Maintenance Manual

Page: 131 / 252

Clearing the error logs
For complete information about using the Configuration/Setup Utility program, see
the
User Guide .
To clear the error logs, complete the following steps:
1. Turn on the server.
2. When the prompt Press F1 for Configuration/Setup is displayed, press F1. If
you have set both a power-on password and an administrator password, you
must type the administrator password to view the error logs.
3. Use one of the following procedures:
v To clear the BMC system-event log, select Advanced Setup , select
Basement Management Controller (BMC) Settings , and then select BMC
System Event Log . Use the Down Arrow key to select Clear BMC SELs ;
then, press Enter. Press Enter to confirm clearing the log, and then press
Esc.
v
To clear the system event/error log, select Event/Error logs , and then select
System Event/Error Log . Use the Down Arrow key to select Clear System
Event/Error Log ; then, press Enter. Press Enter to confirm clearing the log,
and then press Esc.
v
To clear the RSA II event/error log, select Event/Error logs , and then select
RSA II Event/Error Log . Use the Down Arrow key to select Clear RSA II
logs ; then, press Enter. Press Enter to confirm clearing the log, and then
press Esc.
POST error codes
The following table describes the POST error codes and suggested actions to
correct the detected problems.
v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v
See Chapter 3, “Parts listing, RS110 Types 6435, 6436, 6437 and 6438 server,” on page 27 to determine
which components are customer replaceable units (CRU) and which components are field replaceable
units (FRU).
v If an action step is preceded by “(Trained service technician only),” that step must be performed only by a
trained service technician.
Error code Description Action
062 Three consecutive boot failures using the
default configuration.
1. Update the system firmware to the latest level
(see “Updating the firmware” on page 13).
2. (Trained service technician only) Replace the
system board.
101, 102 System board failure. (Trained service technician only) Replace the system
board
Chapter 5. Diagnostics
113