Keysight Technologies InfiniiVision 3000 X Series, User Manual

Page: 301 / 432

Utility Settings
20
Keysight InfiniiVision 3000 X-Series Oscilloscopes User's Guide 301
• Mask — The pass/fail status is evaluated periodically. When the evaluation of
the testing period results in a failure, the trigger output pulses high (+5 V).
Otherwise, the trigger output remains at low (0 V). See Chapter 15 , “Mask
Testing,” starting on page 239.
• Waveform Generator Sync Pulse — All of the waveform generator output
functions (except DC, Noise, and Cardiac) have an associated Sync signal:
The Sync signal is a TTL positive pulse that occurs when the waveform rises
above zero volts (or the DC offset value).
See Chapter 17 , “Waveform Generator,” starting on page 257.
The TRIG OUT connector also provides the User Cal signal. See "To perform user
calibration" on page 301.
Performing Service Tasks
The Service Menu (under [Utility] > Service ) lets you perform service-related tasks:
• "To perform user calibration" on page 301
• "To perform hardware self test" on page 304
• "To perform front panel self test" on page 305
• "To display oscilloscope information" on page 305
• "To display the user calibration status" on page 305
For other information related to oscilloscope maintenance and service, see:
•
"To clean the oscilloscope" on page 305
• "To check warranty and extended services status" on page 306
• "To contact Keysight" on page 306
• "To return the instrument" on page 306
To perform user calibration
Perform user-calibration: