Keysight Technologies InfiniiVision 3000 X Series, User Manual

Page: 349 / 432

CAN/LIN Triggering and Serial Decode
23
Keysight InfiniiVision 3000 X-Series Oscilloscopes User's Guide 349
CAN Serial Decode
To set up the oscilloscope to capture CAN signals, see "Setup for CAN Signals" on
page 345.
To set up CAN serial decode:
1 Press [Serial] to display the Serial Decode Menu.
2 If the decode line does not appear on the display, press the [Serial] key to turn it
on.
3 If the oscilloscope is stopped, press the [Run/Stop] key to acquire and decode
data.
You can use the horizontal Zoom window for easier navigation of the decoded data.
See Also • "Interpreting CAN Decode" on page 350
• "CAN Totalizer" on page 351
• "Interpreting CAN Lister Data" on page 352
• "Searching for CAN Data in the Lister" on page 353
NOTE
For CAN triggering set up see "CAN Triggering" on page 347.
NOTE
If the setup does not produce a stable trigger, the CAN signal may be slow enough that the
oscilloscope is AutoTriggering. Press the [Mode/Coupling] key, then press the Mode softkey
to set the trigger mode from Auto to Normal .