Appendix 5: Regulatory approvals
Connection to party line service is subject to state tariffs. Contact the state public utility commission, public service commission or corporation
commission for information.
Alarm dialling equipment must be able to seize the telephone line and place a call in an emergency situation, even if other equipment (telephone,
answering system, computer modem, etc.) already has the telephone line in use. To do so, alarm dialling equipment must be connected to a
properly installed RJ-31X jack that is electrically in series with and ahead of all other equipment attached to the same telephone line. Proper
installation is depicted in the figure below. Consult your telephone company or a qualified installer if you have any questions concerning these
instructions or about installing the RJ-31X jack and alarm dialling equipment for you.
5.2 Innovation, Scientific and Economic Development Canada (ISED) State-
ment
NOTICE: This Equipment, HS3032/HS3128/HS3248, meets the applicable ISED Canada Terminal Equipment Technical Specifications. This is
confirmed by the registration number. The abbreviation, IC, before the registration number signifies that registration was performed based on a
Declaration of Conformity indicating that ISED Canada technical specifications were met. It does not imply that Industry ISED approved the
equipment.
NOTICE: The Ringer Equivalence Number (REN) for this terminal equipment is 0.1. The REN assigned to each terminal equipment provides an
indication of the maximum number of terminals allowed to be connected to a telephone interface. The termination on an interface may consist of
any combination of devices subject only to the requirement that the sum of the Ringer Equivalence Numbers of all devices does not exceed five.
HS3032 Registration number: IC: 160A-HS3256
HS3128 Registration number IC: 160A-HS3256.
HS3248 Registration number IC: 160A-HS3256.
L’indice d’équivalence de la sonnerie (IES) sert à indiquer le nombre maximal de terminaux qui peuvent être raccordés à une interface
téléphonique. La terminaison d’une interface peut consister en une combinaison quelconque de dispositifs, à la seule condition que la somme
d’indices d’équivalence de la sonnerie de tous les dispositifs n’excède pas 5.
5.3 UL/ULC Installations
This product (HS3032/HS3128/HS3248) has been tested and found in compliance with the following standards:
l
UL1610 Central-Station Burglar-Alarm Units
l
UL365 Police Station Connected Burglar Alarm Units and Systems
l
UL1023 Household Burglar-Alarm System Units
l
UL985 Household Fire Warning System Units
l
UL1635 Digital Alarm Communicator System Units
l
UL1637 Home Health Care Signaling Equipment
l
ULC-S304-16 Standard for Control Units, Accessories and Receiving Equipment for Intrusion Alarm Systems
l
ULC-S559-13 Equipment for Fire Signal Receiving Centers and Systems
l
ULC-S545-02 Residential Fire Warning System Control Units
The subscriber control unit shall provide for the connection of protective wiring, conductors, and attachments in accordance with the Standard for Installation and Clas-
sification of Burglar and Holdup Alarm Systems, UL 681.
This product has also been tested and found in compliance with the ANSI/SIA CP-01-2014 Control Panel Standard – Features for False Alarm Reduction.
This product is UL/ULC listed under the following categories:
l
AMCX/AMCXC Central Stations Alarm Units
l
AOTX Local Alarm Units
l
APAW Police-station-connected Alarm Units
l
DAYRC Central Station Fire Alarm System Units
l
UTOU/UTOUC Control Units and Accessories, Household System Type
l
NBSX/NBSXC Household Burglar Alarm System Units
l
AMTB Control Panels, SIA False Alarm Reduction
- 266 -