Jetter JC-120MC, User Manual

Page: 565 / 634

Jetter AG 565
JC-120MC Automatic copying of controller data
Activating the AutoCopy feature
The AutoCopy function can only be executed when the controller is booting
(i.e. after startup).
You have created the command file and stored it to the respective directory.
If the entry
AutoCopyIni is not available in the configuration file config.ini the
name of the command file and of the directory is set as follows:
Value Remarks
File name autocopy.ini All lower case letters
Directory /SD/ Root directory on the SD card
Since operating system version OS Neue AutoCopy-Funktion of JC-120MC
the following applies:
 Die Datei autocopy.ini kann in einem beliebigen Unterverzeichnis des
Stammverzeichnisses
/SD/
auf der SD-Karte sein.
 Instead of autocopy.ini , you can name the file arbitrarily.
In this case, it is prerequisite that the configuration file config.ini contains the
entry config.ini . This entry defines the directory and file name of the command
file.
To start the AutoCopy function, proceed as follows:
Step Action
1
Switch the controller off.
2
Insert the SD card completely into the SD slot.
3 Set the mode selector to LOAD position.
4
Switch the controller on
5 Wait for the red LED D1 to be lit and for the green LED R and the yellow
LED SD to flash slowly by approximately 1 Hz.

Result: The controller executes the AutoCopy function.
6
Wait for the red LED
D1
and for the green LED
R
to flash slowly by
approximately 1 Hz.

Result: The AutoCopy function is set.
Introduction
Prerequisites
Activating the AutoCopy
feature