Jetter JC-120MC, User Manual

Page: 106 / 634

106 Jetter AG
4 Mechanical and electrical installation
4.8 Configuring the JX2 system bus
This chapter is on configuring the JX2 system bus.
The following table shows the maximum number of modules which you can
connect in parallel to the JX2 system bus of the JC-120MC.
Controller JX2-I/O modules
IP67 modules
JX-SIO
CANopen® modules
JX2 slave modules
JetMove
JC-120MC-4 23 10 4
JC-120MC-8 23 10 8
JC-120MC 23 10 16
The following modules can be connected to the JX2 system bus of a
JC-120MC:
 JX2-I/O modules
 JX2 slave modules
 Servo amplifiers JetMove 1xx, JetMove 2xx, and JetMove 6xx

IP67-I/O modules LioN-S and LJX7-CSL
 JX-SIO and Smart I/O
The following third-party CANopen® modules can be connected to the system
bus of the JC-120MC:
 Valve terminals by Festo
 Valve terminals by SMC

Valve terminals by Bürkert
 I/O system 750 by Wago

Gateway BWU1821 by Bihl+Wiedemann
 EcoStep drives by Jenaer Antriebstechnik
 EPOS drives by maxon

Drives by Festo
 Drives by Lenze
 Milan drive by GFC
Topic Page
Wiring the JX2 system bus ......................................................................... 107
Introduction
Number of connectable
modules
Supported modules
Third-party CANopen®
modules
Contents