Jetter JC-120MC, User Manual

Page: 391 / 634

Jetter AG 391
JC-120MC Programming
Module array and module codes of connected modules
A unique module code is assigned to each module connected to the
JX2 system bus. The JC-120MC enters all modules detected during
initialization into the module array.
Modules are entered into the module array in the following order:
 First, JX2-I/O, JX2 slave modules, and JetMoves are are entered into the
module array according to their position on the JX2 system bus.
Configured dummy modules are entered here, too.
 Then, IP67-I/O modules LioN-S and LJX7-CSL are entered according to
the set module number. Vacant positions between module numbers are
filled with dummy modules.
 Finally, CANopen® modules are entered according to their set module
number. Vacant positions between module numbers are also filled with
dummy modules.
Registers Description
R 200002015
Index to module array
R 200002016 Module array
The module array is accessed indirectly.
Step Action
1
Enter the number of the module in the module array into R 200002015
Index to Module Array .
2
Read out the module code from R 200002016 Module Array .
Module code Module Description
0 JX2-OD8 8 digital outputs
1 JX2-ID8 8 digital inputs
2 JX2-IO16 8 digital inputs and 8 digital outputs
3 JX2-IA4 4 analog inputs
4 JX2-OA4 4 analog outputs
5 JX2-CNT1 Counter module
6 JX2-PRN1 Printer Interface Module
7 JX2-SER1 Module with serial interface
9 JX2-TP20-R Module with operating keys
Module array
Registers - Overview
Reading the module
array
Module codes of JX2-I/O
modules