Jetter JC-120MC, User Manual

Page: 64 / 634

64 Jetter AG
4 Mechanical and electrical installation
Function description of mode selector S11
X14
S11
RUN
STOP
LOAD
Position Behavior after power-up
RUN
The controller launches the application program.
STOP The controller does not launch the application program.
LOAD The controller executes the file autocopy.ini which is located
on the SD card.
The JC-120MC checks the position of selector S11 in the following way:
Step Description
1
Power supply of the controller is at terminal X10.
2 The boot loader of the controller checks the position of selector S11.
If ... ... then ...
... mode selector S11 = RUN or
STOP , ...
... the OS is launched;
--> proceed with step 4.
... selector S11 = LOAD position,
and an SD card has been inserted.
... the OS is launched;
--> proceed with step 3.
... selector S11 = LOAD position,
and an SD card has not been
inserted.
... the boot loader waits until an OS
update is carried out
3 The controller loads the file autocopy.ini .
If ... ... then ...
... the file could be loaded, ... ... the instructions contained in it are
executed.
... the file could not be loaded, ... ... proceed with step 4.
4
The controller checks the position of selector S11.
If ... ... then ...
... mode selector S11 = RUN , ... ... the application program is
launched.
... mode selector S11 = STOP , ... ... the application program does not
start.
Mode selector S11
Functions of the mode
selector