Jetter JC-120MC, User Manual

Page: 70 / 634

70 Jetter AG
4 Mechanical and electrical installation
Replacing the controller JC-120MC
At replacing a controller of the JetControl 120 series, the following
configuration information is retained on the backplane module:
 IP address

Subnet mask
 Gateway
 DNS server
To remove the JC-120MC from the backplane module, proceed as follows:
Step Action
1 Remove power from the JX3 station.
2
Press the upper and lower latches
located on the right half of the
JC-120MC.
Keep the latches pressed.
3
Pull off the controller from the
backplane module.
Introduction
Removing the controller