10
SP
E
C
IF
IC
A
T
IO
N
S
Specifi cations and prices subject to change without notice. Download latest update to this manual on-line.
Below are explanations of service listed in the monthly maintenance charts on previous page.
Explanations of monthly maintenance shall include, but are not limited to the following:
1. SB-120 PLUG(S):
Make sure that the plug is lubed with dielectric grease. Inspect the plug for deep grooving or signs of arcing.
2. MOTOR:
Remove hood and check connections. Spray motor and wiring with corrosion block (J&J #99101).
3. BATTERIES:
Check for corrosion, and spray terminals with battery protectant (J&J #99101). Fill batteries with distilled water weekly, or as
needed. Make sure compartment is ventilated.
‹ DANGER ›
: ***READ BATTERY SAFETY PRECAUTIONS BEFORE HANDLING BATTERIES***
4. PIVOT:
Turn motor and check for smooth operation. If motor doesn’t turn easily, visually inspect pivot and grease if necessary. Electric
motor can turn 270°. Motor stops must be in place and in working order.
5. MOTOR /CHARGER POWER CABLES:
Disconnect and grease terminals. Look for signs of wear (Replace as needed).
6. SUMP PUMP:
Clean strainer as needed. Check pump operation. If pump is not cycled periodically, check all wiring connections. Repair
or replace pump as needed.
7.
PROPELLER GUARD:
Inspect for damage or foreign materials. Replace if damaged.
‹ SAFETY ITEM ›
***WARNING: DO NOT OPERATE IF PROPELLER GUARD IS DAMAGED OR MISSING***
8. HULL:
Keep clean and wax every 200 hours or every 2 months. Use a UV protectant weekly to reduce color fading
(J&J part # 3-60-0034).
9. GENERAL WIRES & CONNECTIONS:
Check all wires and connections for damage and corrosion. Clean or replace as needed.
10. ANODE:
Clean monthly. For year-round parks, replace anode every 6 months. For seasonal parks, replace anode at end of the season.
11. SQUIRTER:
Replace fi lter if necessary. Check integrity of hose, mount and pump. Check pump inlet for obstructions. Replace as needed.
12. TUBE:
Clean with mild detergent. Check condition of tube daily. Check tube pressure weekly using low pressure gauge (J&J #3-96-0024)
and set pressure to 2-3 PSI.
NOTE:
ALL NECESSARY REPAIRS NEED TO BE DONE BEFORE BOAT IS OPERATED. USE J&J AMUSEMENTS
OR EQUIVALENT REPLACEMENT PARTS. INSPECTIONS SHOULD BE DONE BY TRAINED AND QUALIFIED
PERSONNEL.
MONTHLY SERVICE SCHEDULE (Electric)
