Specifi cations and prices subject to change without notice. Download latest update to this manual on-line.
3-28
TESTING THE BOAT CAPTAIN
To bypass the remote control for the squirt pump, disconnect the orange lead from the remote to the black lead of the
switch. Jumper the switch’s black lead to the ground post. The squirt pump and the switch should now work normally.
To bypass the remote control for the motor, disconnect the white lead from the remote to the black lead of the motor solid
state switch. Jumper the switch black lead to the ground post. The motor should work normally.
If testing indicates a problem with the boat captain module, always make sure the transmitter is functioning properly.
NOTICE:
The J&J bumper boat conforms to ASTM standards. These standards require that a device be in place to prevent
inadvertent motor actuation by the rider when entering or exiting the boat. The boat captain is installed to allow the ride
operator to disable the motor during loading and unloading of the boat.
Boat Captain - Wiring (Retro-fit)
Remove black switch wires from
ground terminal. Cut off ring terminals and
replace with female end spade terminals.
Ground
terminal
(negative)
On/Off
switch
Squirter
switch
Positive terminal
Connect orange wire to
black wire from squirter switch.
Connect white wire to black
wire from On/Off switch.
Connect red wire to
positive terminal.
Connect black &
yellow wires to
gound
terminal.
