v. Push in the UltraBay tray.
vi. Attach the SelectaDock base, and then dock your
computer.
vii. Go to step 4 on page 42.
3
If you are going to install a hard disk drive using the
UltraBay back HDD connector, do the following:.
a) Undock the computer. See “Cold Docking and Undocking”
on page 26.
b) Remove the SelectaDock base from the docking station.
See “Removing the SelectaDock Base from the Docking
Station” on page 21.
c) Identify the connector for the hard disk drive
1
.
d) Align and insert your drive into the connector. Fit the
docking station onto the rear of the drive, as shown below,
before inserting the drive. Press the area indicated by
2
until the drive seats firmly
3
.
ATTENTION
To prevent damage to the drive, press only on the area
indicated by
2
.
Chapter 3. Installing and Removing Options
41
Summary of Contents for SelectaDock II
