IBM SelectaDock II, User Manual

Page: 125 / 168

a) Lower slot of the computer
b) Upper slot of the computer
c) Lower slot of the docking station
d) Upper slot of the docking station
4
Select the Reset icon to start setup.
5
Select the first drive to attempt the boot operation.
For example, if you want to start up from the first hard disk drive
in the UltraBay of the docking station, click on HDD 3.
Note: Again, this example assumes that you have two hard disk
drives in the computer.
6
Select the second drive to attempt the boot operation.
For example, if the first drive is removed from the configuration
for some reason, the second drive is used for the boot operation.
7
In the same manner, select the third and fourth drives, if you
wish.
8
Select OK to save the startup sequence.
This completes the setup for the startup sequence.
Note: The SCSI hard disk drive attached to the SelectaDock system
cannot be selected as a startup (boot) drive.
Using a Diskette Drive
The SelectaDock system supports only one diskette drive at a time,
even though the SelectaDock system provides two connectors for
diskette drive, the UltraBay connector, and the external diskette drive
connector. If you connect two diskette drive and use one of the
drives, data on the diskettes will be lost.
Using Multiple Configurations for DOS
If you use the DOS operating system for cold docking, multiple
configurations are useful. To boot one operating system efficiently for
both docked and undocked state, you can use the multiple
Appendix A. Tips, Hints, and Limitations
113