IBM SelectaDock II, User Manual

Page: 38 / 168

Cold Docking and Undocking
This procedure describes how to dock and undock the computer to or
from the SelectaDock system.
The computer you are going to dock must be a 760E series or PCI
bus architecture computer. If you accidentally dock an ISA bus
computer, the docking station warns you with the Attention indicator
and beeps.
Cold Docking
To dock your computer to the SelectaDock system in cold mode, do
the following:
1
Turn off your computer.
2
Undock your computer from the SelectaDock base, if it is
docked.
Note: When performing these steps, if you need information
pertaining to the SelectaDock base, see the SelectaDock
Base Model I Setup Guide.
3
Disconnect all peripheral devices cables from your computer.
4
If you want to protect the drives under the keyboard after
docking, set the lock on your computer. See the computer
user's guide for the procedure.
5
Plug the power cord in the power connector of the docking
station, and then into an electrical outlet.
6
Dock your computer to the SelectaDock system. If you are not
familiar with the computer docking procedure, See the
SelectaDock Base Model I Setup Guide.
26
IBM ThinkPad SelectaDock II User's Guide