IBM SelectaDock II, User Manual

Page: 47 / 168

Installing or Removing a Drive in the UltraBay Tray
This section describes the procedures for installing or removing a
drive in the UltraBay space.
Note: The UltraBay tray is initially included in the docking station
when it is shipped. You can remove the UltraBay tray from the
docking station and instead use the space for a 1-inch-high
drive. To remove the UltraBay tray and use the 1-inch-high
drive space, see “Installing or Removing a Drive in the
1-Inch-High Drive Space” on page 44.
Supported Drives
You can install any of the following drives in the UltraBay. Each drive
should be compatible with the UltraBay of the 760E series computer.
IBM ThinkPad 4X CD-ROM drive
IBM ThinkPad 6X CD-ROM drive
IBM ThinkPad diskette drive
IBM ThinkPad hard disk drive
Up to two IDE drives can be installed in the docking station.
ATTENTION
Only one diskette drive can be attached to the SelectaDock system at
the same time. When an external diskette drive is attached, do not
install a diskette drive in the UltraBay of the docking station. Trying to
operate with both drives can destroy diskette data.
Note: If a noncompatible drive is installed in the UltraBay, the
Attention indicator and beeps warn you that the wrong drive is
installed.
Installing a Drive
To install a drive in the UltraBay, do the following:
1
Make sure the power is turned off.
2
If you are going to install a CD-ROM drive or diskette drive,
or if you are going to install a hard disk drive using the
Chapter 3. Installing and Removing Options
35