![background image](http://html1.mh-extra.com/html/ibm/selectadock-ii/selectadock-ii_user-manual_3330587087.webp)
The setup procedure should be done by an administrator for the
multiuser group.
Setup Procedure
To set up a shared system, the administrator should do the following:
1
For each of the computers that will be used by authorized users,
set the same supervisor password.
Note: Do not let the password be known to the users.
2
In the administrator's computer, install a hard disk drive that will
be shared by the users.
3
Set the hard disk password the same as the supervisor
password.
4
After setting the hard disk password, move the drive to the
shared docking station.
5
Set the multiuser lock in the docking station:
a) If needed, install any PC Cards in the docking station. See
“Installing or Removing a PC Card” on page 59 for how to
install PC Cards.
b) Make sure the security key is set to unlock.
c) Set the multiuser lock on.
Chapter 5. Setting Up for Sharing a SelectaDock System
75
Summary of Contents for SelectaDock II
