IBM SelectaDock II, User Manual

Page: 88 / 168

d) Make sure the UltraBay security knob is locked.
e) Attach the SelectaDock base.
f) Check that the security key cannot be turned to the locked
position.
g) Raise the SelectaDock base lock until it latches.
h) Set the MicroSaver lock to prevent undocking of the
SelectaDock base.
Now the SelectaDock system is ready to be used by users who bring
their computers to the SelectaDock system. Users dock their
computers to the SelectaDock system using cold docking. The users
can access the common hard disk drive without entering the
password.
This completes the setup of the shared system.
Removing the Multiuser Lock
To remove the multiuser lock, do the following:
1
Undock the computer.
2
Unlock the MicroSaver lock, if used.
3
Lower the SelectaDock base lock fully, and then remove the
SelectaDock base.
4
Unlock the multiuser lock.
Refer to the figure in step 5c on page 75, and reverse the
procedure.
76
IBM ThinkPad SelectaDock II User's Guide