![background image](http://html1.mh-extra.com/html/ibm/selectadock-ii/selectadock-ii_user-manual_3330587059.webp)
Attaching a SCSI Device
To attach a SCSI device, do the following:
Make sure the SCSI terminator is removed or disabled on the SCSI
device. To remove the SCSI terminator, see the SCSI device manual.
Enable the auto start of your SCSI device.
Insert the SCSI device into the 1-inch-high drive space. Leave
enough space in the back of the drive so the cables can be
connected.
Insert the two connectors
1
of the cables in the docking station to
the corresponding connectors of the SCSI device.
While pressing the connected cables so that they are not above the
SCSI device, push in the SCSI device until it completely stops and is
latched.
Install the 1-inch-high blank bezel.
This completes the installation in the 1-inch-high drive space.
Removing a Drive
To remove a drive from the 1-inch-high drive space, do the installation
procedure in reverse order.
Chapter 3. Installing and Removing Options
47
Summary of Contents for SelectaDock II
