IBM SelectaDock II, User Manual

Page: 63 / 168

a) To attach the IDE drive, do the following:
Set the IDE mode in the drive to the cable select mode. To
select the cable select mode, see the instructions in the
manual accompanying your IDE drive. If you cannot select
the cable select mode, do one of the following:
If no hard disk is installed in the UltraBay, set the mode
to master mode.
If a hard disk is installed in the UltraBay, set the mode to
slave mode.
Insert the IDE drive into the half-height drive space. Leave
enough space in the back of the drive so the cables can be
connected.
Insert the connector of the IDE cable
1
to the connector of
the IDE drive.
While pressing the connected cables down so that they are
not above the half-height drive space, screw in the
half-height drive tray containing the IDE drive.
See “IDE Setup” on page 64.
Install the top cover.
Chapter 3. Installing and Removing Options
51