A-Tach # 50131
Designed for:
Jeep Compass 2017 - 20__
Only for models with the 7 inch display.
A
-Tach
Mobile Device Mounts
NOTICE:
A-Tach Mounts will not be responsible for
any damage to the vehicle due to the installation
and/or use of the product. The product has been
tested to fit securely to the listed vehicles.
Instructions are provided for your convenience.
You are responsible for the use of the product and
to determine if you have the skill to attach the
product without causing damage to your vehicle or
the product.
Read all instructions and view the photos before
attaching this product.
For best results, hold the vehicle mount over the place where the mount attaches to the dash
BEFORE
attaching the device holder to the vehicle mount to ensure a proper fit with the location. Most often the
mount will appear to be a little too big or small for the intended location. The vehicle mount must be
installed
BEFORE
a device holder is screwed onto the vehicle mount.
Once screwed together the products are considered used and non-refundable.
The vehicle mount is not designed to be attached and taken off the vehicle repeatedly or on a regular basis.
Once it is attached, it should remain attached until you would like to permanently remove it.
WARNING:
AVOID extreme heat conditions. It can damage the device and the mount.
(1) Clean the area where the mount will attach. The
mount will attach into the seams illustrated with the
two arrows in the photo above.
(2) The longer side of the mount will be on the left
side when looking at the part number on the back
of the mount. The longer side will be on the right
from the front of the mount.
(3) Remove the coverings from the tape. Hook the
thin left edge of the mount under/behind the right
frame around the left vent.
(4) Press forward on the right side of the mount
until the thin right edge of the mount hooks into
the seam between the left side of the display
screen and the left frame around the screen.
