routIne taSKS
53
Once a sector is loaded, codes are read for all samples, if samples are not present,
reader will reach code located on the rear of sector. Its reading is equivalent to
“sample is not present”.
When Sample ID is recognized, vial position will match defined sample. If sam-
ple ID was not defined in advance, new sample entry is created with recognized
ID but user will have to complete data.
If one or more codes are not read by the barcode, samples still can be measured;
a window will open containing the detected non coded samples and operator
can accept or reject them.
5.2.6.2 Loading non barcoded samples, calibrators and controls
To place a sample, calibrator or control in a sector, first click in a sector ID
from the list of sectors and then press
Place Sample
. Chose from
Samples,
Cali-
brators
or
Controls
tab, and select the desired sample and sector position. Press
Place
to confirm selection, and then repeat the operation or press
Exit
to re-
turn. Press
Place All
to fill all the free positions in sector with available samples
in a sequential order.
5.2.7 REMOVING A SAMPLE
To remove samples from a sector, first click on a sector ID from the list of
sectors and then press
Remove Sample
. Select the sample IDs or sector posi-
tions to remove. Press
Ok
when done or
Cancel
to abort.
To select more than one item from the list, press and hold
Ctrl
key while select-
ing the new item. To select a range of items, select the first item, then press and
hold
Shift
key while selecting the last item. Alternatively, to extend the selection
use the mouse to click and drag.
5.2.8 PLACING A SECTOR ON THE TRAY
To place a sector on the tray, first click on a sector ID from the sectors list,
then press
Load Secto
r
.
The sample tray drives the first available sector position to the sample sector
insertion/removal area.
Remove the old sector if any, place the new one.
Note that non barcoded sam-
ples have to be assigned to a
sector position before inserted to
a sample tray.
To allow samples to be added
or removed the sector must
be out of the tray. No samples can
be added to or removed from an
on-tray sector.
When sectors are coded for
BCR reading, it is not neces-
sary to declare the sector number,
user will be prompted to put any
sector in the first available posi-
tion. If sector is not coded user
must specify any non-used sector
position.
Summary of Contents for HumaStar 600
