HP 64783A, User Manual

Page: 569 / 816

Run failed during CMB execute (Async_Error 694)
Cause: System failure or target condition.
Action: Run performance verification (pv command), and check target system.
Sequence term not contiguous: <term> (Error 1225)
Cause: This error occurs when you attempt to insert a sequence term that is not
between existing terms or after the last term.
Action: Be sure that the sequence term you enter is either between existing
sequence terms or after the last sequence term.
Sequence term not defined: <term> (Error 1227)
Cause: This error occurs when you attempt to delete or specify a primary branch
expression for a sequence term number that is possible, but is not currently defined.
Action: Insert the sequence term, and respecify the primary branch expression for
that term.
Sequence term number out of range: <term> (Error 1224)
Cause: This error occurs when a sequencer qualification command specifies a
non-existent sequence term. The easy configuration sequencer may have a
maximum of four sequence terms. Eight sequence terms exist in the complex
configuration sequencer.
Action: Reenter the command using an existing sequence term.
Severe error detected, file transfer failed (Error 411)
Cause: An unrecoverable error occurred during a transfer operation.
Action: Retry the transfer. If it fails again, make sure the data communications
parameters are set correctly on the host and on the HP 64700. Also make sure you
are using the correct command options, both on the HP 64700 and on the host.
Chapter 12: Emulator Error Messages
Run failed during CMB execute (Async_Error 694)
539