HP 64783A, User Manual

Page: 182 / 816

To run programs from the transfer address
•
Choose Execution
→
Run
→
from Transfer Address.
•
Using the command line, enter:
run from transfer_address
Most software development tools allow you to specify a starting or entry address
for program execution. That address is included with the absolute file’s symbolic
information and is known by the interface as the "transfer address".
Before you can run from the transfer address, it must exist in the absolute file, and
you must load symbols along with the program code from the absolute file. If the
interface does not detect a transfer address, this menu item is grayed-out and
unresponsive to mouse clicks.
To run programs from reset
•
Choose Execution
→
Run
→
from Reset.
•
Using the command line, enter:
run from reset
This command resets the emulation processor and begins executing your target
program at either the start address for the processor, or at the address fetched from
the reset vector for the processor. It may be necessary to supply a reset signal from
your target system as well. See your processor-specific documentation for
information about the exact mechanism involved.
Chapter 4: Using the Emulator
Using Processor Run Controls
152