Operating Manual HG G-98830YA | English, Revision 02 | Date: 21.06.2021
75
Update the Antenna Software – Chapter 11
Figure 34
Update program: The operating elements
Select the desired hex file (
1
).
Set the serial interface and the baud rate (
2
).
Activate the field
Send Bootstrap Comand
(
3
).
To start the update:
Switch the antenna on click on the
Program
(
4
) button within 10 seconds.
A system reset will follow and after a short time the file will be transferred.
If an error occurs during the transfer, status messages colored red are output. As
long as only green messages appear (
5
), the software update is proceeding correctly.
The last 2 messages of a normal update process are:
ProgramFlash: Ok
and
CloseCom: Ok
After a successful software update, you can close the program.
Click the
close
(
6
) button.
The antenna is now working with the new software.
2
Selection of the serial
1
Selection of the Hex-file
5
Status messages
4
Start of the programming
6
Exiting the program
to be transmitted
3
This option must always
be activated
interface and baud rate
process
