Operating Manual HG G-98830YA | English, Revision 02 | Date: 21.06.2021
64
Chapter 10 – Configuration of the System via the Service Interface
Setting the CAN baud rate
You can either select a predefined data rate or adjust the bit timing. If you adjust the
bit timing, the corresponding baud rate and sample point are always displayed.
Normally the predefined baud rates are sufficient. Adjust the bit timings only if you
are familiar with the timing of CAN controllers!
With the parameter
CAN-(B)aud
you select a predefined data rate.
Selection:
20, 50, 125, 250, 500, 1000 kB
To select a predefined baud rate:
Press the key
and enter the desired value.
With the parameters
B(R)P Baudrate Prescaler
,
S(J)W Sync Jump Width
,
Tseg(1)
and
Tseg(2)
you can adjust the Bit timing.
Value ranges:
B(R)P Baudrate Prescaler
: 0 … 63
S(J)W Sync Jump Width:
0 … 3
Tseg(1)
: 2 … 15
Tseg(2)
: 1 … 7
To adjust the Bit-Timing :
Press the keys
,
,
or
and enter the desired value.
Setting the output behavior
With the parameter
(T)ime Period
you set how often a permanent output of the data
should take place. The parameter
Co(n)tinous Telegrams
must be set to 1.
Value ranges:
4 … 500 ms
To set the time between two data outputs:
Press the key
and enter the desired value.
With the parameter
Co(n)tinous Telegrams
you set whether a permanent output
takes place according to the time period set with
, or whether the output takes
place when a transponder is decoded in the field.
Selection:
0 = The output occurs when a transponder is decoded in the field..
1 = The output is permanent.
To select this function:
Press the key
.
To switch off this function again:
Press the key
again.
