Operating Manual HG G-98830YA | English, Revision 02 | Date: 21.06.2021
50
Chapter 10 – Configuration of the System via the Service Interface
–
Did you transfer the correct configuration file?
–
Did you choose the correct baud rate?
–
Did you use the appropriate text document?
–
Is the system configured correctly?
–
Did you wait at least 10 (or 26) seconds after switching on the antenna?
–
Are you using a different monitor program and did not set a character delay
of 1 ms?
If you change interface parameters, they will only become active when the system
is switched off and on again (system reset.
10.2 Using the Monitor Program
10.2.1 Main Menu
Figure 23
Main menu of the monitor program
The item (Q)uit Monitor will only appear if the serial interface is set to a procedure
other than Monitor only. In this case, quit the monitor program with
, so that the
serial interface switches back to the configured 3964R or transparent output.
NOTICE
Modifying the antenna parameters may detune the antenna!
The changes to the antenna parameters described below can detune the
antenna to such an extent that normal operation is no longer possible!
Save the transponder antenna configuration before each change so that you
can restore it if necessary (see 10.2.16 „(1) Import / (2) Export User
Parameter“ on page 72).
S:0006 D:+006 D_X:+32767 D_Y:+32767 Code: 00000001 Read: 42: N: 0
Frx[/Hz]:66800 Ftx[/Hz]:127990
U[/mV]:24000 I[/mA]: 270 T[Grd.C]:+33 E: 0002 Noise 0
(S)erial Output
(T)ime & Code
(F)requency & Antenna tuning
Basic C(A)N-Parameters
CA(N)-Open-Parameters
(D)isplay Systemstatus
Cs(v) [38,4 KB Code,Us,X,Y,Tr,Co,S-,Pos,N,E,Cnt<crlf>](abort with <a>)
(Y) display Histogram
(W)rite Transponder
[L]oad Userparameters to EEProm
[U]pdate Firmware
(1) Import User Parameter from Host to Antenna
(2) Export User Parameter from Antenna to Host
P(r)int Parameters
(Q)uit Monitor
Software Version 98830A21.004 / Oct 20 2016 Serial Number: 0
