Operating Manual HG G-98830YA | English, Revision 02 | Date: 21.06.2021
62
Chapter 10 – Configuration of the System via the Service Interface
Tuning the transmitting antenna
With the parameter
(A)ntenna tuning
you can tune the transmitting antenna by set
-
ting the current consumption to maximum. This will give you the greatest range.
Value range:
0 … 15, +, -
To tune the transmitting antenna:
Press the key
.
Enter a value or adjust the values using the keys
and
.
Switch transmitter on/off for control purposes
With the parameter
switch (T)ransmitter
you can switch the transmitter on or off for
control purposes. When leaving the monitor, the value is automatically set to 1.
Selection:
0 = The transmitter is switched off.
1 = The transmitter is switched on for control purposes.
To switch the transmitter on or off for control purposes:
Press the key
and enter the desired value.
10.2.8 Basic C(A)N-Parameters
In the
Basic C(A)N-Parameters
menu you can set the different parameters for the
CAN bus.
To switch from the main menu to the menu Basic
C(A)N-Parameters
you have to:
Press the key
.
The following menu is shown:
Figure 29
Menu: C(A)N-Parameters
SR = 63: ACK ERROR / / / EWRN /
(!)Antenna-ID: front (01)
(C)AN active YES
(E)xtended CAN STANDARD
(Y)dentifier: TX [0..2047]: 80
(X)-Identifier: TX [0..2047]: 82
(D)-Identifier: TX [0..2047]: 81
(S)-Identifier: TX [0..2047]: 0
CAN-(B)aud [20,50,125,250,500,1000 kB]: 250.0
B(R)P Baudrate Prescaler [0..63]: 1
S(J)W Sync Jump Width [0..3]: 0
Tseg(1) [2..15]: 15
Tseg(2) [1..7]: 2 sp: 80 %
(P)eriod [4.500mS]: 8
Co(n)tinous Telegrams 1
CAN on Re(m)ote Request 0
(F)reeze Values for n Telegrams [0..20]: 0
(O)rder of Data Transfer (0= HiByte first): 0
(Q)uit Menue
