Operating Manual HG G-98830YA | English, Revision 02 | Date: 21.06.2021
60
Chapter 10 – Configuration of the System via the Service Interface
Selection:
0 = The positioning pulse switches off when the voltage S falls below the
threshold defined in the
(L)evel for Positioning/Calculation
parameter.
1 = The positioning pulse switches off after the time defined in the
(P)osi Pulse
Time
parameter.
To select this function:
Press the key
.
To switch this function off again:
Press the key
again.
Defining the behavior of the positioning pulse output
With the parameter (C)CODE_OK -> POSI_OUT you define the behavior of the Posi
-
Pulse output.
Selection:
0 = The CODE_OK-Bit is switched to the output.
1 = The positioning pulse is switched to the output.
To select this function:
Press the key
.
To switch this function off again:
Press the key
again.
Setting the threshold for the scan coils
With the parameter
Th(r)eshold MAX-Detection
you can set a threshold value for the
scan coils that must be reached so that the transverse deviation in X and Y direction
is calculated. For setting the thresholds, refer to chapter 8 „Commissioning“ on page
31.
Value range:
10 … 1023
To set the threshold value for the scan coils:
Press the button
and enter the desired value.
10.2.7 (F)requency & Antenna Tuning
Use the
(F)requency & Antenna Tuning
menu to enter the frequency for the antenna
and tune it.
To switch from the main menu to the menu
(F)requency & Antenna Tuning
:
Press the key
.
The following menu is shown:
