Operating Manual HG G-98830YA | English, Revision 02 | Date: 21.06.2021
14
Chapter 3 – Scope of Delivery
3
Scope of Delivery
The scope of supply includes:
one transponder antenna HG G-98830YA
protective caps for the M12 connectors
an operation manual
3.1 Required Accessories
The transponder antenna alone is not sufficient for position detection of vehicles
with transponders.
To operate a driverless transport system you also need:
a connection cable for connecting the antenna to the vehicle electronics,
several transponders in the ground.
The connection cables can be assembled by the customer (see Preparation of Con
nection Cables) or ordered from Götting (see below). No Götting cables are available
for the Profinet® interface.
Refer to Table 3 for the order numbers of the required accessories.
Table 3
Required accessories
Order No.
Description
HW CAB00001 For connector POWER:
Connection cable PUR, 5 m with M12 angular coupling,
5-pin, A-coded
HW CAB00064 For connector CAN 2:
Connection cable CAN bus, 10 m, with shielding, one end
M12 socket 5-pin straight, A-coded (can also be used for
connector POWER)
HW CON00055 For connector CAN 1:
CAN terminating resistor (terminator),
M12 plug 5-pin, A-coded
HW DEV00095 Disc transponder
Usually mounting on the roadway
HW DEV00098 Disc transponder pre-programmed
Usually mounting on the roadway
HG G-71325XA Rod transponder
Usually mounting in the ground
