Chapter 4 Function/System Settings and Display
4.4 Miscellaneous > set audit
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED
P2X0-1030-09ENZ0
584
set audit
This command changes the general settings of the audit log function. Use the "show audit" command to dis-
play the audit log function settings that are configured by this command.
■
Syntax
■
Parameter
set audit [-mode {enable | disable}]
[-server1-function {disable | rfc3164 | rfc5424}]
[-server1
audit_log_server1
] [-server1-port-number
port_number
]
[-server1-port {maintenance | remote}]
[-server2-function {disable | rfc3164 | rfc5424}]
[-server2
audit_log_server2
] [-server2-port-number
port_number
]
[-server2-port {maintenance | remote}]
-mode
Optional. This parameter specifies whether to enable the audit log function.
enable
The audit log function is enabled.
disable
The audit log function is disabled.
-server1-function
Optional. This parameter specifies whether to enable syslog server 1. If omitted, the existing
setting is not changed. If omitted, the existing setting is not changed. This parameter cannot
be specified when the audit log function is disabled.
disable
Syslog server 1 is disabled.
rfc3164
Syslog server 1 is enabled and uses message format based on RFC3164.
rfc5424
Syslog server 1 is enabled and uses message format based on RFC5424.
-server1
Optional. This parameter specifies syslog server 1. Only one server can be specified. The server
name format should be IPv4 standard notation (a base 256 "d.d.d.d" string), IPv6 address
format, or a fully qualified domain name (FQDN). The types of IPv6 addresses that can be
specified are global addresses (including 6to4 addresses), link local addresses, and unique
local addresses. Up to 63 alphanumeric characters can be specified. If omitted, the existing
setting is not changed. This parameter cannot be specified when the audit log function is dis-
abled.
Example: -server1 192.168.1.20
Example: -server1 fd80::abd0:223:ad
Example: -server1 foo.bar
-server1-port-number
Optional. This parameter specifies syslog server 1's UDP port number for the syslog protocol.
Specify the port number within 1 to 5 digits. The port number cannot be set above 65535. If
omitted, the setting is not changed. The default value is 514. This parameter cannot be speci-
fied when the audit log function is disabled.
Summary of Contents for Eternus DX410 S2
Page 2: ...This page is intentionally left blank ...
Page 756: ......